LDL on your report: calculated or directly measured?
Most LDL cholesterol results are not measured directly. They are calculated from total cholesterol, HDL cholesterol and triglycerides using an equation, usually Friedewald or Martin-Hopkins. The method matters most when triglycerides are high or LDL…

En este artículo
Most LDL cholesterol results are not measured directly. They are calculated from total cholesterol, HDL cholesterol and triglycerides using an equation, usually Friedewald or Martin-Hopkins. The method matters most when triglycerides are high or LDL is low. Your report should say which method was used. Discuss any borderline result with your doctor.
Key takeaways
- LDL cholesterol on a routine report is usually an estimate, because the reference method (ultracentrifugation) is only available in specialised laboratories [5][7].
- The Friedewald equation assumes a fixed ratio between triglycerides and VLDL cholesterol. It becomes less reliable when triglycerides rise and should not be used above 400 mg/dL (4.5 mmol/L) [5][7].
- The Martin-Hopkins equation adjusts that ratio for each person and is more accurate when LDL is low or triglycerides are moderately high [2][4][7].
- Direct LDL assays exist, but they have their own bias, especially in people with abnormal lipids [5][8].
- Non-HDL cholesterol and ApoB are useful companions to LDL when the estimate is uncertain [5][7].
Why LDL is usually calculated
LDL cholesterol is the cholesterol carried inside low-density lipoproteins. The reference way to measure it separates lipoproteins by ultracentrifugation. A Spanish consensus document on lipid testing describes this method as time-consuming and only available in specialised laboratories [7].
So most laboratories measure three things instead: total cholesterol, triglycerides and HDL cholesterol. They then subtract the cholesterol that is not in LDL. The tricky part is VLDL cholesterol, which is not measured. Each equation is, at heart, a different way of guessing VLDL cholesterol from triglycerides.
The three equations you may see
Friedewald (1972)
Friedewald, Levy and Fredrickson published their equation in 1972, based on 448 patients [1]. In mg/dL it reads: LDL = total cholesterol − HDL − triglycerides/5. In mmol/L the divisor is 2.2 [5].
The fixed divisor assumes every VLDL particle carries cholesterol and triglycerides in the same proportion. That is not true when triglycerides rise. The 2019 ESC/EAS guidelines note that calculated LDL can underestimate LDL cholesterol from triglycerides of 2 mmol/L (177 mg/dL) and that the formula cannot be used above 4.5 mmol/L (400 mg/dL) [5]. The guidelines also warn that at very low LDL levels the calculated value may be misleading [5].
Martin-Hopkins (2013)
Martin and colleagues derived their method from 1,350,908 lipid profiles [2]. Instead of always dividing by 5, it picks a divisor from a 180-cell table based on the person's triglycerides and non-HDL cholesterol [2]. The authors reported better classification into guideline LDL categories than Friedewald [2].
An "extended" version was later developed for triglycerides of 400 to 799 mg/dL. In a study that included the developers of the method, among 111,939 patients in that range, it classified LDL correctly in 62.1% of cases, against 19.3% for Friedewald [4]. For LDL below 70 mg/dL, the figures were 67.3% and 5.1% [4]. The authors added that all equations still underclassified low LDL in this group, so caution is needed [4].
Sampson (NIH, 2020)
The Sampson equation was published in 2020 by a team at the US National Institutes of Health [3]. It was designed for people with normal lipids or with triglycerides up to 800 mg/dL [3]. The Spanish consensus notes that, below 400 mg/dL, it gives results similar to Martin-Hopkins and is used less often [7].
Directly measured LDL
"Direct LDL" means an automated chemical assay that measures LDL cholesterol in the sample without an equation. It does not need a triglyceride value, so it can be used in samples with high triglycerides.
It is not perfect. A study in Clinical Chemistry compared direct methods from several manufacturers with the reference procedure [8]. Five of eight LDL methods met accuracy goals in people without disease, but none did in people with dyslipidaemia or cardiovascular disease [8]. The ESC/EAS guidelines also note systematic bias in direct methods, especially at high triglycerides [5].
Which method fits which situation
| Situation | Method recommended by the source | Source | Caveat |
|---|---|---|---|
| Triglycerides below 150 mg/dL and LDL above 100 mg/dL | Friedewald is accurate in most people | Spanish consensus [7] | Accuracy falls as triglycerides rise |
| Triglycerides 150 to 400 mg/dL, LDL below 70 mg/dL, or a non-fasting sample | Martin-Hopkins preferred | Spanish consensus [7] | Still an estimate |
| Triglycerides 400 mg/dL (4.5 mmol/L) or higher | Do not use equations; use direct LDL | Spanish consensus [7], ESC/EAS [5] | Direct assays can be biased in dyslipidaemia [8] |
| Direct LDL not available | Use non-HDL cholesterol or ApoB | Spanish consensus [7] | Interpretation needs clinical context |
These cut-offs describe when a method is reliable. They are not healthy ranges. LDL targets depend on your overall cardiovascular risk, and reference ranges vary between laboratories, and by sex and age. Your doctor is the right person to tell you which target applies to you.
Does fasting matter?
For most people, no. A joint EAS and EFLM statement recommends non-fasting lipid profiles for routine testing [6]. After a usual meal, triglycerides rise by about 0.3 mmol/L and LDL falls by about 0.2 mmol/L on average, which the authors did not consider clinically significant [6].
Triglycerides are the value most affected by food. Because Friedewald depends on triglycerides, the Spanish consensus recommends Martin-Hopkins or non-HDL cholesterol when triglycerides are above 150 mg/dL [7]. It recommends a repeat fasting sample if triglycerides are 4.5 mmol/L (398 mg/dL) or higher [7].
Non-HDL cholesterol and ApoB
Non-HDL cholesterol is total cholesterol minus HDL. It needs no triglyceride value and is not affected by fasting [7]. It reflects the cholesterol carried by all atherogenic particles [5].
ApoB counts those particles, because each one carries a single ApoB molecule [7]. The ESC/EAS guidelines report that measured LDL and ApoB can disagree in around 20% of patients [5]. If your LDL estimate looks uncertain, ask your doctor whether these markers would add useful information.
What to look for on your report
- The method. Look for "calculated", "Friedewald", "Martin-Hopkins", "Sampson" or "direct" next to LDL.
- Your triglycerides. If they are high, the estimated LDL is less reliable.
- Whether you fasted. Note it when you compare results over time.
- Comparisons over time. A change in method or laboratory can shift the number. Keep this in mind before reading a trend.
Measuring LDL at Santé Labs
LDL cholesterol, total cholesterol, HDL and triglycerides are part of our Glycaemic Control Profile, which you can book now in Barcelona.
Our Standard Lipid Profile is coming soon. It covers total cholesterol, HDL, LDL, triglycerides and the atherogenic index, but not ApoB. We do not currently offer ApoB or the atherogenic index in any bookable profile. We measure and explain your results. Diagnosis and treatment decisions belong with your doctor.
FAQ
Is a calculated LDL less valid than a measured one?
Not necessarily. In most people with normal triglycerides, equations perform well [7]. Direct assays also have limitations in people with abnormal lipids [8].
Why did my LDL change when I switched labs?
Laboratories may use different equations, assays and reference ranges. A method change alone can shift the result. Discuss the trend with your doctor.
My triglycerides are high. Is my LDL wrong?
It may be less precise. Friedewald should not be used above 400 mg/dL [5][7]. Ask your doctor whether a direct LDL, non-HDL cholesterol or ApoB would help.
Do I need to fast before a lipid test?
Usually not [6]. A fasting repeat is recommended if triglycerides are 4.5 mmol/L or higher [7]. Other tests in the same panel, such as fasting glucose, may still need fasting.
Which equation is best?
Studies favour Martin-Hopkins over Friedewald when LDL is low or triglycerides are raised [2][4][7]. No equation replaces clinical judgement.
References
- Friedewald WT, Levy RI, Fredrickson DS. Estimation of the concentration of low-density lipoprotein cholesterol in plasma, without use of the preparative ultracentrifuge. Clin Chem. 1972 – https://pubmed.ncbi.nlm.nih.gov/4337382/
- Martin SS, et al. Comparison of a novel method vs the Friedewald equation for estimating low-density lipoprotein cholesterol levels from the standard lipid profile. JAMA. 2013 – https://pubmed.ncbi.nlm.nih.gov/24240933/
- Sampson M, et al. A new equation for calculation of low-density lipoprotein cholesterol in patients with normolipidemia and/or hypertriglyceridemia. JAMA Cardiol. 2020 – https://pubmed.ncbi.nlm.nih.gov/32101259/
- Sajja A, et al. Comparison of methods to estimate low-density lipoprotein cholesterol in patients with high triglyceride levels. JAMA Netw Open. 2021 – https://pmc.ncbi.nlm.nih.gov/articles/PMC8554644/
- Mach F, Baigent C, et al. 2019 ESC/EAS Guidelines for the management of dyslipidaemias. Eur Heart J. 2020 – https://pubmed.ncbi.nlm.nih.gov/31504418/
- Nordestgaard BG, et al. Fasting is not routinely required for determination of a lipid profile. EAS/EFLM joint consensus statement. Eur Heart J. 2016 – https://pubmed.ncbi.nlm.nih.gov/27122601/
- Arrobas Velilla T, et al. Consensus document for lipid profile testing and reporting in Spanish clinical laboratories. Adv Lab Med. 2023 – https://www.degruyterbrill.com/document/doi/10.1515/almed-2023-0047/html
- Miller WG, et al. Seven direct methods for measuring HDL and LDL cholesterol compared with ultracentrifugation reference measurement procedures. Clin Chem. 2010 – https://pubmed.ncbi.nlm.nih.gov/20378768/


